Village QV36B Specifications download pdf (Page 18)

18 Quadra-fire • QV32B, QV36B • 2013-900 Rev. F • 9/06

Step 3. Installing the Vent System

A. Vent System Approvals

These models have vent starting collars on both the top

and the back of the unit. Depending upon the installation,

decide which ONE set of starting collars will be used to

attach the vent system. The starting collar sealing cap must

remain on the starting collar NOT used.

These models use SL-D-series, direct vent components

when using the TOP vent collars. This pipe is tested and

listed as an approved component of the fireplace. The pipe

is tested to be run inside an enclosed wall. There is no

requirement for inspection openings at each joint within the

wall. There is no required pitch for horizontal vent runs.

These models also use DVP-series direct vent components

when using the REAR vent collars.

The flame and ember appearance may vary based on the

type of fuel burned and the venting configuration used.

Identifying Vent Components

Approved vent system components are labeled for identifi-

cation. NO OTHER VENTING SYSTEMS OR COMPO-

NENTS MAY BE USED. Detailed installation instructions

are included with each vent termination kit and should be

used in conjunction with this Installers Guide. Figure 8

shows vent system components and terminations.

The vent systems installed on this gas fireplace may in-

clude one, two, or three 90°

elbow assemblies. The rela-

tionships of vertical rise to horizontal run in vent configura-

tions using 90° elbows MUST BE strictly adhered to. The

rise to run relationships are shown in the venting drawings

and tables. Refer to the diagrams on the next several pages.

NOTE: Two 45° elbows may be used in place of one

90° elbow. Maximum and minimum rise to run ratios

must always be maintained in the vent system when

using 45° elbows.

Figure 8. Vent System Components and Termination Kits

Vent System Termination Kits

Vent System Components

* For use with flex vent only.

** For use on IPI units only.

HORIZONTAL

TERMINATION

WALL

FIRESTOP

90 DEGREE

ELBOW

VERTICAL

TERMINATION

STORM COLLAR

ROOF FLASHING

HORIZONTAL PIPE

SUPPORT

PIPE LENGTH

WALL BRACKET

CEILING

FIRESTOP

SLK-991DA

SLK-01TRD

SLK-01TRF

DVP-TVHW

SL D-SERIES

DVP-SERIES

SL-FLEX2-01TRF

(SL-Series)

DVP-TRAP

DVP-TB1

DVP-TV

PVK-80

SLK-SNKD

(Required

to have a

minimum of 3

feet of vertical

in the vent

system)

(There

MUST be a 25%

reduction in total H

when using the snorkel

cap except when using

the simple up and out

installation (see Fig. 9)

(For use with both DVP

and SL-D venting)

WARNING: YOU MUST NOT MIX DVP-SERIES

AND SL D-SERIES COMPONENTS IN ANY VENT

SYSTEM CONFIGURATION.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Comments to this Manuals

No comments

Village QV36B Specifications Page 18

Comments to this Manuals

Related products and manuals for Fireplaces Village QV36B