Village QV36B Specifications download pdf (Page 28)

28 Quadra-fire • QV32B, QV36B • 2013-900 Rev. F • 9/06

B. Installing Vent Components

After determining which set of starting collars will be used (top

or rear), follow venting instructions accordingly.

Venting Out the Rear Vent (See Figure 21)

Remove the installed rear seal cap from the rear starting collars

by cutting the strap at each end. Remove the insulation inside

the 5” collar. Follow the vent configuration tables accordingly.

Remove the 5” diameter heat shield from the 5” diameter collar

by sliding it out.

WARNING: THE TOP HEAT SHIELD (INSIDE

THE FIREBOX) MUST REMAIN ATTACHED IF

THE VENT SYSTEM IS ATTACHED TO THE

REAR STARTING COLLARS. SEE FIGURE 21.

Venting Out the Top Vent

Remove the top vent collar seal cap by cutting the strap at

each end. Remove the insulation inside BOTH the 4”

diameter and 6 5/8” diameter collars. (See Figure 21).

Remove the 4” diameter heat shield from the 4” diameter

collar by sliding it out.

You have to take the glass off for positioning the logs when the

unit is finally installed in place and finished around it. Attach

vent system to the top starting collars.

WARNING: THE REAR VENT COLLAR SEAL CAP

MUST REMAIN ATTACHED TO THE REAR VENT

COLLARS IF THE VENT SYSTEM IS ATTACHED TO

THE TOP STARTING COLLARS. SEE FIGURE 21.

WARNING: FAILURE TO REMOVE INSULATION

IN THE SET OF COLLARS YOU ARE USING

COULD NEGATIVELY AFFECT FIREPLACE

PERFORMANCE.

WARNING: YOU MUST LEAVE THE INSULA-

TION IN PLACE IN THE SET OF COLLARS YOU

ARE NOT USING. FAILURE TO DO THIS COULD

CAUSE A FIRE.

DVP Series Venting Only:

1. Attaching the Venting to the Fireplace

Refer to Cinch Pipe and Termination Cap installation in-

structions.

WARNING: ENSURE THAT THE FIBERGLASS

GASKET SUPPLIED WITH THE FIREPLACE

SEALS BETWEEN THE FIRST VENT COMPONENT AND

THE OUTER FIREPLACE WRAP.

2. Continue Adding Vent Components

Refer to Cinch Pipe and Termination Cap installation in-

structions.

• Continue adding vent components, locking each succeed-

ing component into place.

• Ensure that each succeeding vent component is secure-

ly fitted and locked into the preceding component in the

vent system.

• 90° elbows may be installed and rotated to any point

around the preceding component’s vertical axis. If an el-

bow does not end up in a locked position with the pre-

ceding component, attach with a minimum of two (2)

sheet metal screws.

3. Install Support Brackets

Refer to Cinch Pipe and Termination Cap installation in-

structions.

Go to Step 4 Install Firestops.

Figure 21.

Remove two screws

holding heat shield.

Venting Out Rear Venting Out Top

HEAT

SHIELD

DISCARD

INSULATION

SEAL

CAP

SEAL

CAP

HEAT

SHIELD

INSULATION,

DISCARD

BOTH

PIECES

HEAT

SHIELD

TOP VENT

COLLAR

(UNDERNEATH)

If the installation is for a termination cap attached directly

to the fireplace, skip to the sections, Install Firestops and

Vent Termination.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Comments to this Manuals

No comments

Village QV36B Specifications Page 28

Comments to this Manuals

Related products and manuals for Fireplaces Village QV36B