Village QV36B Specifications download pdf (Page 29)

29Quadra-fire • QV32B, QV36B • 2013-900 Rev. F • 9/06

For Vertical Runs - The vent system must be supported

every eight (8) feet (2.4m) above the fireplace flue outlet by

wall brackets. To install support brackets for vertical runs:

• Attach wall brackets to the vent pipe and secure the wall

bracket to the framing members with nails or screws.

Figure 23. Installing Support Brackets

2. Continue Adding Vent Components

• Continue adding vent components, locking each succeed-

ing component into place.

• Ensure that each succeeding vent component is secure-

ly fitted and locked into the preceding component.

• 90° elbows may be installed and rotated to any point

around the preceding component’s vertical axis. If an el-

bow does not end up in a locked position with the pre-

ceding component, attach with a minimum of two (2)

sheet metal screws.

Figure 22. Adding Venting Components

3. Install Support Brackets

For Horizontal Runs - The vent system must be supported

every five (5) feet of horizontal run by a horizontal pipe support.

To install support brackets for horizontal runs:

• Place the pipe supports around the vent pipe.

• Nail the pipe supports to the framing members.

WALL BRACKET

WALL STUD

1 INCH MIN.

(25.4mm)

8 FT. (2.4m)

FLUE

OUTLET

If the installation is for a termination cap attached directly

to the fireplace, skip to the sections, Install Firestops and

Vent Termination.

SL-D and SL-Flex Series Venting Only:

1. Attach the First Vent Component to the

Starting Collars

To attach the first vent component to the starting collars

of the fireplace:

• Lock the vent components into place by sliding the con-

centric pipe sections with four (4) equally spaced interior

beads into the fireplace collar or previously installed com-

ponent end with four (4) equally spaced indented sections.

• When the internal beads of each outer pipe line up, ro-

tate the pipe section clockwise about one-quarter (1/4)

turn. The vent pipe is now locked together.

• Slide the ceramic fiber pad over the first vent section and

place it flush to the fireplace (see Figure 1). This will

prevent cold air infiltration. High temp caulk may be used

to hold the part in place. Continue to add vent compo-

nents.

Go to Step 4 Install Firestops.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Comments to this Manuals

No comments

Village QV36B Specifications Page 29

Comments to this Manuals

Related products and manuals for Fireplaces Village QV36B